You\u2019ve just spent weeks nurturing or gathering your precious protein samples. By your calculations, there should be just enough material to complete your experiments. The workflow begins; an extraction, a purification step, maybe even some trypsin, then off to the mass spectrometry lab. But when the results finally come back, the data are, shall we say, beneath your expectations. But why? Should you blame the low coverage and poor reproducibility on the MS instrument? Or did the problem arise even before the instrument was turned on?<\/p>\n\n\n\n
While the answer will not be definitive, one thing you probably already know is that sample preparation is just as important as the instrument choice at the back end of your experiment. Poor extraction and incomplete purification effectively erases all of the efforts you put into obtaining your valuable samples.<\/p>\n\n\n\n
This has happened to me, it\u2019s happened to all of us. Ask yourself two SIMPLE questions on your sample preparation:<\/p>\n\n\n\n Do you know your protein RECOVERY?<\/strong><\/p> Do you know your protein PURITY?<\/strong><\/p><\/blockquote><\/figure>\n\n\n\n There are multiple options when it comes to protein sample preparation. You want something simple: fast, reliable, and easy to use. But what matters even more than that is to ensure that you can isolate your protein in high yield, and free of contaminants. The answer to all of this is the classic technique of solvent precipitation. Before you run away, let\u2019s just take a closer look at this process. You might not realize the incredible potential of this simple approach.<\/p>\n\n\n\n When an organic solvent such as acetone is added to a solution of dissolved proteins, what exactly happens? The answer, believe it or not, depends entirely on what else is in the solution. We\u2019ll get to that in a minute. But let\u2019s look at the protein solution first. Perhaps these proteins were aided to dissolve by adding a surfactant, such as SDS. Good choice! After all, almost nothing beats SDS when it comes to dissolving proteins. SDS can therefore be used to aid the initial extraction step. Of course, if mass spectrometry is your end goal, this SDS will need to be eliminated. So maybe you avoided SDS in the first place. Maybe there is very little in your solution besides protein and water.<\/p>\n\n\n\n Now let\u2019s add the acetone. What happens next is that the addition of acetone causes individual proteins to stack together and ultimately precipitate. The conventional explanation for this is that the water shell surrounding the protein is being whittled away by the addition of organic solvent. Essentially, less water means less shielding of attractive forces, and the proteins come together. At least, that\u2019s what we were hoping. But sometimes things don\u2019t go as planned. Protein precipitation was long considered a \u201chit-or-miss\u201d approach to recover proteins. Some days it works, and other days (or other protein samples), it\u2019s a different story.<\/p>\n\n\n\n Now, why would a process be so inherently variable? Unless of course, not all the variables are controlled. Here\u2019s where the question of what else is in solution really matters. Turns out, an organic solvent alone is insufficient to precipitate proteins. You can try it for yourself. Take a pure protein (BSA is a good choice) and dissolve it in pure water. Now start adding acetone. You would expect that, beyond a critical amount of solvent, the protein will precipitate. But you will find that it does not. In fact, very few proteins will \u2013 even in 90% solutions of acetone. But here\u2019s where it gets interesting. Try adding a pinch of salt, and watch what happens.<\/p>\n\n\n\n